LED
Front location
The LEDs located at the front of the CANmod.gps are illustrated below.
Front overview
LED Short Name |
LED Color |
Main Function |
|---|---|---|
PWR |
Green |
Power |
CH1 |
Yellow |
CAN-bus activity (channel 1) |
MEM |
Red |
Memory activity |
PWR
The Power LED is constantly on when the device is in normal operation. Exceptions to this are:
When a custom configuration file is rejected (the LED toggles each 500 ms a total of 10 times, then stays on).
When the firmware is being updated (for more information go to the Firmware update section).
CH1
The Channel 1 LED indicates CAN-bus activity.
Note
CAN-bus activity is indicated by turning the CH1 LED on for 25 ms. The LED will be constantly on if the time between CAN-bus messages is less than 25 ms.
Note
Activity on the USB virtual CAN bus does not trigger the LED.
MEM
The Memory LED indicates memory activity (eg. configuration parsing and USB memory access).
Back location
The LED located at the back of the CANmod.gps is illustrated below.
Back overview
LED Short Name |
LED Color |
Main Function |
|---|---|---|
SIG |
Blue |
GNSS signal |
SIG
Constant off: Initializing
Constant on: Waiting for fix
Flashing (1Hz): Fix obtained
Note
The initialization step can take several seconds depending on the device configuration.