Installation

This section outlines the installation requirements that shall be satisfied.

Supply

The device can be powered by either Supply (5 V) (DB9, pin 1), Supply (5-24 V) (DB9, pin 9) or the USB connector. Make sure to only connect one supply at a time to avoid damaging the device.

Danger

Make sure to only connect one power source at a time[1].

Supply quality

The nominal voltage shall be kept within specifications at all times. The device is internally protected against low energy voltage events which can be expected as a result of supply wire noise, ESD and stub-wire inductance.

If the supply line is shared with inductive loads, care should be taken to ensure high energy voltage events do not reach the device. Automotive environments often include several sources of electrical hazards, such as load dumps (disconnection of battery while charging), relay contacts, solenoids, alternators, fuel injectors etc. The internal protection circuitry of the device is not capable of handling high energy voltage events directly from such sources.

Grounding

ISO 11898-2 tolerates some level of ground offset between nodes. To ensure the offset remains within range, it is recommended to use a single point ground reference for all nodes connected to the CAN-bus. This may require the ground wire to be carried along with data wires.